xConnect 3-Pin Male Pigtail – 50cm / 20in Round Waterproof

The xConnect 3-Pin Male Pigtail is a 20-inch (50 cm) round-cable pigtail designed for custom pixel wiring, controller and receiver builds, repairs, and other addressable RGB lighting projects. It uses 18 AWG conductors and a sealing ring for a secure, weather-resistant connection when properly mated with a compatible female xConnect connector.

The opposite end is unterminated for direct wiring to a controller, receiver board, terminal block, power-injection harness, or other compatible device.

• xConnect 3-pin male connector
• 50 cm / 20 in cable length
• 18 AWG conductors
• Round outer cable jacket
• Sealing ring for weather-resistant mating
• Ideal for custom wiring, repairs, controller builds, and pixel-lighting projects

Product Overview

This pigtail provides a simple way to add or replace a male xConnect connection in a pixel-lighting system. The 20-inch cable length provides useful routing flexibility while keeping enclosure and harness wiring manageable.

The round cable jacket also works well with cable glands and other strain-relief hardware commonly used in weather-resistant controller and receiver enclosures.

Key Features

• Standard xConnect compatibility for common 3-wire addressable pixel systems
• 18 AWG wiring for positive, negative, and data conductors
• 50 cm / 20 in length for flexible routing and custom wiring
• Weather-resistant connector design when properly mated with a compatible female xConnect connection
• Unterminated wire end for direct connection to controllers, terminals, harnesses, or custom wiring
• Suitable for new builds or replacing damaged pigtails

Wire Color Reference

Important: Wire colors and connector pinouts can vary between manufacturers and pixel products. Always verify polarity and pinout before applying power.

Technical Specifications

Typical Applications

• Custom pixel-lighting cables
• Controller and receiver wiring
• Replacement xConnect pigtails
• Power-injection and custom harness builds
• DIY pixel-controller projects
• Outdoor addressable RGB lighting systems

Installation Notes

• Verify connector pinout and polarity before applying power.
• Use appropriate strain relief or cable glands where the pigtail passes through an enclosure wall.
• The weather-resistant seal depends on a fully seated and properly tightened compatible xConnect connection.
• Protect unused male connectors with a compatible female end cap when exposed outdoors.

Recommended Accessories

• Cable ID Clips - Label controller and harness connections for easier setup and troubleshooting.
• Plastic End Cap - Female Cap for Male xConnect - Protect unused male xConnect connectors from dust and moisture.
• M25 4-Hole Cable Gland - Route multiple round pigtail cables through one enclosure opening.